Updated Juniper JN0-363 Dumps – Check Free JN0-363 Exam Dumps (2023)
Updated JN0-363 exam with Juniper Real Exam Questions
The JN0-363 certification program is recognized globally and is highly valued in the networking industry. Service Provider Routing and Switching, Specialist (JNCIS-SP) certification program is designed to help individuals gain a competitive advantage in the job market and enhance their career prospects. Service Provider Routing and Switching, Specialist (JNCIS-SP) certification program also provides individuals with the opportunity to join the Juniper Networks Certification Program (JNCP) community, which is a global community of networking professionals who have gained expertise in Juniper Networks technologies.
The JN0-363 exam covers a wide range of topics related to service provider routing and switching, including OSPF, IS-IS, BGP, MPLS, Layer 2 VPNs, and Layer 3 VPNs. Candidates must have a solid understanding of these technologies, as well as the ability to configure, troubleshoot, and optimize them in a service provider network.
NEW QUESTION # 87
You are using RSVP to signal an MPLS LSP.
Which statement is true in this scenario?
- A. A secondary path must be configured to establish an LSP.
- B. The traffic engineering database must be used for all LSPs.
- C. LSPs can be configured without any traffic engineering constraints.
- D. A primary path must be configured to establish an LSP.
Answer: C
NEW QUESTION # 88
Click the exhibit.
In the exhibit, which two routers will perform a swap action on LSP1? (Choose two.)
- A. R4
- B. R1
- C. R3
- D. R2
Answer: B,D
NEW QUESTION # 89
You own a small company and need to assign IPv6 addresses to your routers. Because you want to follow the guidelines spelled out in RFC 3177, you want to design your network with the correct prefixes.Which prefix would your ISP likely allocate to your company?
- A. 48-bit prefix
- B. 128-bit prefix
- C. 47-bit prefix
- D. 64-bit prefix
Answer: A
NEW QUESTION # 90
Which two statements are true about IP and GRE tunnels? (Choose two.)
- A. The TTL field is changed in the inner IP packet header
- B. Tunnel endpoints need a valid route to the remote endpoint
- C. Tunnel traffic is encrypted
- D. The protocol field is changed in the inner IP packet header
Answer: A,B
NEW QUESTION # 91
Which statement is true about an OSPF broadcast link?
- A. All routers form an adjacency only with the BDR
- B. All routers form an adjacency with all other routers
- C. All routers form an adjacency only with the DR
- D. All routers form an adjacency with both the DR and BDR
Answer: D
Explanation:
https://sites.google.com/site/amitsciscozone/home/juniper-junos/junos--ospf-designated-router
NEW QUESTION # 92
Which type of router can provide connectivity between areas in an IS-IS domain?
- A. a Level 2 router with adjacencies in a single area
- B. a Level 1 router with adjacencies within a single area
- C. an area border router with adjacencies in more than one area
- D. a Level 2 router with adjacencies in more than one area
Answer: D
NEW QUESTION # 93
What are two benefits of using an OSPF designated router (DR)? (Choose two.)
- A. Reduces LSA flooding on a broadcast segment.
- B. Reduces LSA flooding throughout an OSPF area.
- C. Reduces router resources used.
- D. Reduces the size of the link-state database.
Answer: A,C
NEW QUESTION # 94
Which prefix in the output shown in the exhibit is an external prefix injected by an OSPF router?
- A. 192.108.1.4
- B. 172.18.1.0/24
- C. 192.168.1.3
- D. 172.26.4.0730
Answer: D
NEW QUESTION # 95
Click the Exhibit button.
Referring to the exhibit, which two statements are true? (Choose two.)
- A. The configuration is for an internal BGP session
- B. The configuration is for an external BGP session
- C. The local-address statement is required for the BGP session to establish correctly
- D. The multi-hop statement is required for the BGP session to establish correctly
Answer: A,C
NEW QUESTION # 96
You are adding nonforwarding route reflectors to your network. Which three actions ensure that VPN routes are advertised properly? (Choose three.)
- A. Add MPLS LSPs between the route reflectors and their client routers.
- B. Add a static default route to inet.3 and/or inet6.3 on the route reflectors.
- C. Use rib-groups to add IGP routes to inet.3 and/or inet6.3 on the route reflectors.
- D. Add the route reflectors to the same IGP domain as their clients.
- E. Use rib-groups to add VPN routes to inet.0 and/or inet6.0 on the route reflectors.
Answer: A,B,C
NEW QUESTION # 97
Click the Exhibit.
On an MX Series device, you must enable routing between VLANs 100,200, and the Internet ge-5/1/0, and ge-5/1/2 are bundled into interface ae3. Ge-5/1/4, and ge-5/1/5 are bundles into interface ae2. Both AE bundles trunk VLANs 100 and 200.
In this scenario, what is the correct configuration snippet for VLAN 100?
- A. interfaces {xe-2/1/0 {unit 0{family inter {address 10.0.10.2/24;}}}irb {unit 0{family inet {address 10.0.1.2/24;}}unit 1 family inet {address 10.0.2.2/24;}}}}bridge- domains {vlan- 100{domain-type bridge;vlan-id 100;interface ge-2/2/2.100;interface ae1.100;interface ae3.100;routing-interface irb.0;}}
- B. interfaces {xe-2/1/0{unit 0{family inet {address 10.0.10.2/24;}}}ip-0/0/0{unit 0{family inet {address 10.0.1.2/24;}}unit 1{family inet {address 10.0.2.2/24;}}}}bridge- domains {vlan- 100{domain-type bridge;vlan-id 100;interface ge-2/2/2.100;interface ae1.100;interface ae3.100;interface ip-0/0/0.0;}}
- C. interfaces {xe-2/1/0 {unit 0 {family inet {address 10.0.10.2/24;}}}irb {unit 0{family inet {address 10.0.1.2/24:}}unit 1 {family inet {address 10.0.2.2/24;}}}}bridge- domains {vlan- 100{domain-type bridge;vlan-id 100;interface ge-2/2/2.100;interface ae1.100;interface ae3.100;}}
- D. interfaces {xe-2/1/0 {unit 0{family inet {address 10.0.10.2/24;}}}ip-0/0/0 {unit 0 {family inet {address 10.0.1.2/24;}}unit 1 {family inet {address 10.0.2.2/24;}}}} bridge-domains {vlan- 100{domain-type bridge;vlan-id 100;interface ge-2/2/2.100;interface xe-2/1/0.0;interface ae1.100;interface ae3.100interface ip-0/0/0.0;}}
Answer: C
NEW QUESTION # 98
Click the Exhibit.
You are planning the addition of a new EX3400 Series device to the network (EX-3400-7) to service MSTI-1 and MSTI-2.
Referring to the exhibit, which requirement must be met on EX-3400-7 for the MSTP instances to become fully operational and resilient?
- A. The MSTP revision-level must be incremented.
- B. The MSTP configuration-name must be the same.
- C. The CIST must be extended to EX-3400-7.
- D. The bridge-priority must match EX-3400-5 and EX-3400-6.
Answer: B
NEW QUESTION # 99
Click the Exhibit.
Referring to the exhibit, which two statements are true? (Choose two.)
- A. The LSP is protected with fast reroute.
- B. The last node in the path will not pop the MPLS label.
- C. The LSP is protected with link protection.
- D. The last node in the path will pop the MPLS label.
Answer: C,D
NEW QUESTION # 100
Click the Exhibit button.
You configured R1 and R2 to form an OSPF adjacency, but the adjacency will not establish.
Referring to the exhibit, which statement correctly identifies the problem?
- A. Hello and dead timers are not matching between R1 and R2
- B. R1 does not have a router ID defined
- C. R2 has a wrong area configured
- D. R1 and R2 have the same router ID
Answer: D
Explanation:
https://www.juniper.net/documentation/en_US/junos/topics/reference/configuration-statement/router-id-edit-routing-options.html
NEW QUESTION # 101
Which statement describes integrated routing and bridging (IRB) interfaces?
- A. An IRB interface assigns interfaces to VLANs.
- B. An IRB interface defines a bridge domain.
- C. An IRB interface enables Layer 2 switching on the router.
- D. An IRB interface Is an IP gateway For hosts of a bridge domain.
Answer: C
NEW QUESTION # 102
......
Passing the JN0-363 exam is a great achievement for networking professionals who want to advance their careers in the field of service provider networks. Service Provider Routing and Switching, Specialist (JNCIS-SP) certification demonstrates that candidates have a thorough understanding of Juniper Networks service provider routing and switching platforms and can design, configure, and troubleshoot complex networks. The JN0-363 certification is recognized globally, and it can open up new job opportunities for candidates in the service provider networking industry.
Actual JN0-363 Exam Recently Updated Questions with Free Demo: https://learningtree.actualvce.com/Juniper/JN0-363-valid-vce-dumps.html